In architectural drafting, the working drawings are all plans, elevations, and details needed by the contractor along with the specifications, so that an estimate can be obtained and then the building can be constructed. These need to show all dimensions and be properly scaled. Any oddities of construction must be made clear on these drawings and they must be so complete in a way that no extra money can be charged to the owner by the contractor who bid the job as is shown in the working drawings and specifications. Below is a general description of what they contain.
First Floor Plan
The plan of the first floor is almost always the first plan to be drawn. With the conventional drawings to follow, it is a simple matter to draw any plan. Almost all residential drawings are made to the scale of one quarter inch equals one foot. The outside walls are drawn in first, scaling four to six inches for frame buildings, and then the interior partitions and details. It is then completely dimensioned even though it scales exactly to size because the dimensions are of greater importance. You would not expect the framer to have to use a scale to find where the walls are placed.
Second Floor Plan
The outside walls of this plan and the main partitions are derived from the first floor plan. If possible, run the second floor partitions over the first, or as near to them as practical to carry weight down to the foundation or basement.
Basement Plan
The plan of the basement is also derived from the first floor plan because its outside dimensions are the same. The main wall is made of masonry block or concrete that is eight to twelve inches thick, rests upon an twenty four inch wide footing, and runs up to and beyond the grade line (ground level). Through the center, to support the long span of the joists, a girder is run. This is then held up by posts resting on a concrete footing. You have to be very careful to dimension the basement plan exactly because it is the foundation of the structure and the first part of the building that is to be built. Some drafters will locate the heater, waste pipe, and sewer outlet on this plan.
Elevations
The exterior views called the elevations comes next. The floor plan is placed over the elevation that is being drawn, and all the points projected up to it. When one elevation is finished, its heights can be projected to the next view in the same manner.
Section or Sections
The section is where a horizontal line is cut through the building as if chopped with a knife to show how the building is constructed. A scaled section clears up a lot of confused detail. It shows all trim, stairs, and construction details in a way that there is very little room for confusion. The section is one of the most important drawings and it should not be neglected or omitted in any way.
Resource : http://EzineArticles.com/?expert=Tim_J._Davis
Republish by - http://www.architecturaldraftingindia.com
